Primer paint for indoor works
Colour: White
Consumption: 8-12 m2/L.
Drying time: 1–2 hours at 20°С and relative air humidity of 50%.
Volume / weight: 0,9L – 2,25L – 4,5L – 9L – 18L
White, deep matt water-borne paint for priming walls and ceilings in dry and wet rooms
Maximum permissible VOC content for the product (subcat a): 30 g/L; maximum VOC content in the product: < 30 g/L.
Gloss:
Wash resistance:
Recommended as primer coat before painting walls and ceilings with water-borne paints in dry and wet rooms. Moreover, the paint can be used for finishing majority of rooms with normal operational conditions and also corridors, workshops, stairwells etc. Can be used on new and previously painted surfaces from all types of mineral bases, including concrete, aerated concrete, gyps plaster boards or chipboards, plastered surfaces and covered with fiberglass wallpapers or other roll finishing material. Not suitable for finishing floors, doors and furniture.
New or previously painted surfaces made of concrete, aerated concrete, gypsum board, primed wood chipboard or wood fibre board; brick, surfaces filled with putty and plastered and surfaces covered with glass fibre wallpaper or other paintable finishing materials.
The surface to be painted must be carefully cleaned from peeling material, dirt and dust. If mould removal is necessary, use Biotol E or Biotol Spray Sandpaper durable alkyd substrates until they are matt and remove the dust thoroughly. If the surface is very dirty, wash it with EasyClean. Use a putty from the FILLER line to fill cracks, holes and uneven areas. Sand the filled surface to make it even and remove sanding dust. Prime filled surfaces with Aquastop or Tiefgrund moisture barrier to reduce porosity.
Stir the paint thoroughly before application. The paint can be diluted with water in the amount of up to 5% of its volume for the application of the first coat. Apply 2 coats with a roller or spray gun at the temperature between 10 °C and 25 °C and relative humidity not exceeding 80%.
In case the paint job is carried out in adverse conditions (draughts, the use of heating appliances, high temperature or low air humidity), we recommend using the Time+ slow-dry agent in the amount of up to 3% of the paint volume (mix 0.33 L of Time+ into 9 L of paint).
Treat the surface with care for 4 weeks after painting until its hardness and wash resistance have reached their peak levels. We recommend using water and neutral or medium alkaline detergents (pH below 9).
Do not use organic solvents and hard scrubbing brushes or sponges. Wipe the surface dry after wet cleaning. Use Biotol E and Biotol Spray to remove mould. Use soft sponges and cloths for cleaning.
If necessary, the surface can be lightly wiped with a soft sponge or cloth approximately 48 hours after paint application.
Roller (pile length: 10-14 mm), airless spray gun (nozzle: 0.021–0.027”).
Wash with soap and water after completing work.
Store and transport in intact containers at the temperature between +5°С and +30°С. Protect from exposure to freezing and direct sunlight.
The information concerning the product is based on the results of laboratory tests and practical use of the product depending on the location and conditions of its use. As the manufacturer, we guarantee the quality of the product and provide the best recommendations for its appropriate application. As the manufacturer, we cannot control the conditions and circumstances of product transportation, storage and application and numerous other factors that affect its use. Thus, we shall not bear responsibility for the damage caused by ignoring the instructions for use or transportation, by noncompliance with storage conditions and timeframes or by inappropriate application of the product. The manufacturer reserves the right to alter product information at their discretion without prior notice.
Kulu arvutatakse 1 kihile
