Water-borne semi-matt varnish for interior use
Colour: White, transparent after drying
Consumption: 8-10 m2/L
Drying time: Dust-free drying time: 0.5 hour; at the temperature of +20 °C and the relative humidity of 65%, the surface is ready for the application of another coat in 1–2 hours. If the temperature is lower and the humidity is higher, the drying takes longer accordingly.
Volume / weight: 0,95L – 2,4L
Acrylate semi-matt varnish for indoor wooden surfaces.
Maximum permissible EU VOC content for the product (subcat e): 130 g/L. Maximum VOC content in the product ˂130 g/L
Gloss:
Decorative and protective finishing of wall and ceiling panels, logs, beams, baseboards etc. in dry rooms.
Wooden surfaces.
Can be used to coat concrete, brick, plastered stone and dyed wooden surfaces as well as previously painted surfaces or surfaces covered with paper wallpaper to ensure their moisture and wash resistance.
The varnish is not meant for furniture, steam rooms, floors and surfaces subject to heavy mechanical wear.
The surface must be clean and dry. Wood moisture content must not exceed 20%.
Remove the old peeling coating from previously varnished surfaces. Dampen rough surfaces, using a spray bottle, let it dry; sand off the fibres of wood raised by dampening; remove dust thoroughly.
Sand glossy surfaces until they are matt; remove dust thoroughly.
Stir the varnish thoroughly before application and keep stirring it regularly during the working process to spread tinting pastes and the matt agent evenly.
If necessary, the varnish can be diluted with water in the amount of 10% of its volume for the first coat. Application in the conditions of exposure to direct sunlight, draughts and high temperature can cause surface defects.
We recommend applying 2–3 coats of varnish along the grain without stopping from one edge of the surface to the other at the temperature between +10°C and +25°C and at relative humidity not over 80%.
Sand the surface slightly and remove dust before applying another coat.
The colour of the surface coated with tinted varnish depends on the species and hue of the wood and the number of varnish coats.
Before applying tinted varnish, we recommend making a swatch on a separate board to check the tint.
We recommend using non-tinted varnish for the final coat.
The coating reaches its peak hardness in about 4 weeks; in the meantime, treat the surface with care until its hardness and wash resistance have reached their peak levels.
If necessary, the surface can be lightly wiped with a soft sponge or cloth approximately 48 hours after varnish application.
We recommend using water and neutral or medium alkaline detergents (pH below 9) for cleaning.
Do not use organic solvents, abrasive cleansers and hard scrubbing brushes or sponges.
Short-pile velour roller, brush, airless spray gun (0.013–0.015’’ nozzle). We recommend using a brush for application to provide better protection of wooden surfaces.
Wash with soap and water after completing work.
Store and transport in undamaged containers at the temperature between +5°C and +35 °C. Protect from freezing and direct sunlight.
The information concerning the product is based on the results of laboratory tests and practical use of the product depending on the location and conditions of its use. As the manufacturer, we guarantee the quality of the product and provide the best recommendations for its appropriate application. As the manufacturer, we cannot control the conditions and circumstances of product transportation, storage and application and numerous other factors that affect its use. Thus, we shall not bear responsibility for the damage caused by ignoring the instructions for use or transportation, by noncompliance with storage conditions and timeframes or by inappropriate application of the product. The manufacturer reserves the right to alter product information at their discretion without prior notice.
Kulu arvutatakse 1 kihile
