Weather-resistant varnish for stone
Colour: Transparent.
Consumption: 8–10 m²/L. Varnish consumption depends on the type of the surface.
Drying time: At the temperature of +20 °C and the relative humidity of 80%, the surface is ready for the application of another coat in 2 hours and is fully dry in 24 hours. At a lower temperature and higher humidity, the drying time is longer.
Volume / weight: 1L – 3L
Solvent-borne varnish based on special solvent-borne acryl resins for the decorative and protective finish of mineral surfaces.
Maximum permissible EU VOC content for the product (subcat. h): 750 g/L. Maximum VOC content in the product <750 g/L.
Gloss:
For the protection of various mineral surfaces from adverse weather effects and for decorative finish.
Application: elements of façades and fences, stone terraces and pavements, wall and floor tiles, mantelpieces, interior decoration elements, etc.
Not intended for polished or glazed surfaces.
Do not use on facing brick prone to blooming.
Do not use on façades where sectional waterproofing between the foundations and the walls has been damaged.
For indoor and outdoor use.
Natural and artificial stone, brick, concrete, clinker, plaster.
The surface must be durable, dry and cleaned from salt efflorescence, sand, dust, dirt, oil and grease.
Previously painted surfaces must be cleaned from peeling material, sandpapered and rinsed with water. Areas damaged with mould or moss growth must be thoroughly cleaned mechanically and then treated with Biotol E or Biotol Spray, rinsed with water and dried.
Do not perform the application in direct sunlight, at high temperatures and in case of exposure to draughts. Before application, stir the varnish thoroughly. Apply at the temperature of the varnish, the surface and the air above +10 °С and relative humidity below 80%. One coat of the varnish is enough for the “wet stone” effect on moderately absorbing surfaces. On porous surfaces, apply the second coat of the varnish in 2 hours. Dilute with appropriate thinner (White-Spirit, paint thinner, xylol, turpentine) by 25% if necessary. We recommend renewing the varnish coating annually on stone surfaces that are exposed to aggressive weather elements or intensive mechanical wear.
The coating will reach its peak wash resistance in about 4 weeks: during this period, treat the surface with care until its hardness and wash resistance have reached their peak levels. If necessary, the surface can be lightly wiped with a soft sponge or cloth approximately 48 hours after varnish application. We recommend using water and neutral or medium alkaline detergents (pH below 9). Do not use organic solvents, abrasive cleansers and hard scrubbing brushes or sponges.
Brush, roller, sponge
Wash with solvent (White-Spirit, paint thinner) and then with soap and water after completing work.
Keep container tightly closed. Store at the temperature below +30 °С. Store in a well-ventilated place. Store locked up. Keep cool. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
The information concerning the product is based on the results of laboratory tests and practical use of the product depending on the location and conditions of its use. As the manufacturer, we guarantee the quality of the product and provide the best recommendations for its appropriate application. As the manufacturer, we cannot control the conditions and circumstances of product transportation, storage and application and numerous other factors that affect its use. Thus, we shall not bear responsibility for the damage caused by ignoring the instructions for use or transportation, by noncompliance with storage conditions and timeframes or by inappropriate application of the product. The manufacturer reserves the right to alter product information at their discretion without prior notice.
Kulu arvutatakse 1 kihile
