Decorative varnish for stone
Colour: White; transparent after drying.
Consumption: 8-12 m²/L. Varnish consumption depends on the type of the surface
Drying time: At the temperature of +20 °C and the relative humidity of 80%, the surface is ready for the application of another coat in 1–2 hours and is fully dry in 2–4 hours. At a lower temperature and higher humidity, the drying time is longer.
Volume / weight: 0,95L-2,4L
Water-borne acrylic varnish for the decorative and protective finish of mineral surfaces.
Maximum permissible EU VOC content for the product (subcat. e) 130 g/L. Maximum VOC content in the product <130 g/L.
Gloss:
For the decorative and protective finish of various mineral surfaces: elements of façades and fences, façade and wall tiles, mantelpieces, and interior decoration elements.
ot intended for the finishing of horizontal surfaces in high foot traffic areas (paving flagstone, path paving stone), polished or glazed surfaces. Do not use on facing brick prone to blooming. Do not use on façades where sectional waterproofing between the foundations and the walls has been damaged.
Natural and artificial stone, brick, concrete, clinker, plaster.
The surface must be durable, dry and cleaned from salt efflorescence, sand, dust, dirt, oil and grease. Previously painted surfaces must be cleaned from peeling material, sandpapered and rinsed with water. Areas damaged with mould or moss growth must be thoroughly cleaned mechanically and then treated with Biotol E or Biotol Spray, rinsed with water and dried.
Do not perform the application in direct sunlight, at high temperatures and in case of exposure to draughts. Before application and in the process of working, stir the varnish thoroughly but carefully (to make sure you do not cause air bubbles to form in it). Stirring ensures that the gloss of the varnish coating will be even when it dries. One coat of the varnish is enough for the “wet stone” effect on moderately absorbing surfaces. On porous surfaces, apply the second coat of the varnish in 1—2 hours. Dilute by 25% if necessary. We recommend renewing the varnish coating annually on stone surfaces that are exposed to aggressive weather elements or intensive mechanical wear.
The coating will reach its peak wash resistance in about 4 weeks: during this period, treat the surface with care until its hardness and wash resistance have reached their peak levels. If necessary, the surface can be lightly wiped with a soft sponge or cloth approximately 48 hours after varnish application. We recommend using water and neutral or medium alkaline detergents (pH below 9). Do not use organic solvents, abrasive cleansers and hard scrubbing brushes or sponges.
Brush, roller, sponge.
Wash with water after completing work.
Store and transport in undamaged containers at the temperature between +5 °C and +30 °C. Protect from freezing and direct sunlight.
The information concerning the product is based on the results of laboratory tests and practical use of the product depending on the location and conditions of its use. As the manufacturer, we guarantee the quality of the product and provide the best recommendations for its appropriate application. As the manufacturer, we cannot control the conditions and circumstances of product transportation, storage and application and numerous other factors that affect its use. Thus, we shall not bear responsibility for the damage caused by ignoring the instructions for use or transportation, by noncompliance with storage conditions and timeframes or by inappropriate application of the product. The manufacturer reserves the right to alter product information at their discretion without prior notice.
Kulu arvutatakse 1 kihile
