Varnish for sauna
Colour: White; transparent after drying.
Consumption: 10-14 m²/L
Drying time: Dust-free drying time: 0.5 hour; at the temperature of +23 °C and the relative humidity of 50%, the surface is ready for the application of another coat in 2–3 hours. If the temperature is lower and the humidity is higher, the drying takes longer accordingly.
Volume: 0,95L – 2,4L
Water-borne acrylate varnish for protection of wood and stone surfaces against moisture and heat
Maximum permissible EU VOC content for the product (subcat. e) 130 g/L. Maximum VOC content in the product <130 g/L.
Gloss:
To protect walls, ceilings, window frames, doors and baseboards in wet rooms (saunas and washrooms, steam rooms, locker rooms, garages, basements, caissons). Not recommended for treating sauna benches or floors. Please use Sauna Oil or Saunavaha Vihta for treating sauna benches.
Wooden, wood fibre, concrete, brick and stone surfaces.
The surface must be cleaned from dirt, grease and dust. Remove the old peeling coating from previously varnished surfaces. Dampen rough surfaces, using a spray bottle, let it dry; sand off the fibres of wood raised by dampening; remove dust thoroughly.
Stir the varnish thoroughly before application. Apply two coats along the grain, using a soft brush or a roller (one coat in steam rooms). Wait for 2–3 hours after applying the first coat to apply the second coat. We recommend sanding the surface slightly before applying the second coat. Carefully remove dust after sanding. The varnish can be diluted with water if necessary (not more than 5%).
The coating will reach its peak wash resistance in about 4 weeks: during this period, treat the surface with care until its hardness and wash resistance have reached their peak levels. If necessary, the varnished surface can be lightly wiped with a soft sponge or cloth approximately 48 hours after varnish application. We recommend using water and neutral or medium alkaline detergents (pH below 9). Do not use organic solvents, abrasive cleansers and hard scrubbing brushes or sponges.
Roller, brush.
Wash with soap and water after completing work.
Contains 1,2-benzisothiazol-3(2H)-one, 2-methylisothiazol-3(2H)-one, reaction mass of 5-chloro-2-methyl-2H-isothiazol-3-one and 2-methyl-2H-isothiazol-3-one (3:1). May produce an allergic reaction. If medical advice is needed, have product container or label at hand. Keep out of reach of children.
Avoid release to the environment. Dispose of the contents/containers in accordance with the current legislation on waste treatment.
Waste treatment methods: code 08 01 12- waste paint and varnish other than those mentioned in 08 01 11; waste class: Non dangerous Regulation (EU) No 1357/2014.
Store in undamaged containers at the temperature between +5 °C and +35 °C. Protect from freezing and direct sunlight.
The information concerning the product is based on the results of laboratory tests and practical use of the product depending on the location and conditions of its use. As the manufacturer, we guarantee the quality of the product and provide the best recommendations for its appropriate application. As the manufacturer, we cannot control the conditions and circumstances of product transportation, storage and application and numerous other factors that affect its use. Thus, we shall not bear responsibility for the damage caused by ignoring the instructions for use or transportation, by noncompliance with storage conditions and timeframes or by inappropriate application of the product. The manufacturer reserves the right to alter product information at their discretion without prior notice.
Consumption is calculated for 1 layer
